Write your message
   [Home ] [Archive]    
:: Main :: About :: Current Issue :: Archive :: Search :: Submit :: Contact ::
:: Spring ::
Back to the articles list Back to browse issues page
Wave Reflection of irregular waves from Multi-Layer Berm Breakwaters
Majid Ehsani1, Mohammad Navid Moghim *1, Mehdi Shafieefar2, Amir Mostaghiman1
1- Department of Civil Engineering, Isfahan University of Technology
2- Department of Civil and Environmental Engineering, Tarbiat Modares University
Abstract:   (143 Views)
One of the issues that emerge from an efficacious design of berm breakwaters is an estimation of wave reflection. In the present study, the wave reflection of a multi-layer berm breakwater (MLBB) has been studied based on model experimentation. To gain this goal, two-dimensional model tests have been carried out in a wave flume at Tarbiat Modares University. Irregular waves were generated using the JONSWAP spectrum, under which the effect of various parameters like wave height, wave period, water depth, and berm elevation from still water level is investigated on the wave reflection. Achieved outcomes of this study propose a new formula estimating MLBBs wave reflection. Ultimately, the performance of the derived formula against the existing formulae proposed by other researchers is checked thoroughly. The results of the statistical evaluation indices divulge that the predicted wave reflection using the new formula is more accurate than the existing ones. Thus, it would be obvious that the present formula can provide a well-founded estimation of wave reflection on the MLBBs. Moreover, the new formula and those estimated by existing ones are validated by employing the data set exclusively used in drawing the comparison. This fair validation illustrates that the current formula is more accurate than the existing formulae.
Keywords: Wave Reflection|Multi-layer berm breakwater|Experimental study|Prediction formula ,
Full-Text [PDF 1218 kb]   (58 Downloads)    
Type of Study: Research | Subject: Coastal Engineering
Received: 2020/03/17 | Accepted: 2020/10/21
References
1. Moghim, M.N. and Lykke Andersen, T., (2015), Armor stability of hardly (or partly) reshaping berm breakwaters, Coastal Engineering, Vol. 104, p.1-12. [DOI:10.1016/j.coastaleng.2015.06.003]
2. Ehsani, M., Moghim, M.N. and Shafieefar, M., (2017), The latest researches and accomplishments in the design rules of Icelandic berm breakwaters, 16th Iranian Hydraulic Conference, Ardabil, Iran. (In Persian)
3. Lykke Andersen, T., (2006), Hydraulic Response of Rubble Mound Breakwaters. Scale Effects - Berm Breakwaters. PhD Thesis, Aalborg University.
4. Tørum, A., Moghim, M.N., Westeng, K., Hidayati, N. and Arntsen, Ø.A., (2012). On Berm Breakwaters: Recession, Crown Wall Wave Forces, Reliability, Coastal Engineering. Vol. 60, p.299-318. [DOI:10.1016/j.coastaleng.2011.11.003]
5. Sigurdarson, S., Viggosson, G., Benediktsson, S. and Smarason, O.B., (1996), Berm breakwaters, tailor-made size graded structures, 11th International Harbour Congress, Antwerp, Belgium.
6. Van der Meer, J.W., (1995), Conceptual design of rubble mound breakwaters, In Advances in Coastal and Ocean Engineering, Vol. 1, p.221-315. [DOI:10.1142/9789812797582_0005]
7. Chang, H.K. and Hsu, T.W., (2003), A two-point method for estimating wave reflection over a sloping beach. Ocean engineering, Vol. 30(14), p.1833-1847. [DOI:10.1016/S0029-8018(03)00017-9]
8. Davidson, M.A., Bird, P.A.D., Bullock, G.N. and Huntley, D.A., (1996), A new non-dimensional number for the analysis of wave reflection from rubble mound breakwaters. Coastal Engineering, Vol. 28, p.93-120. [DOI:10.1016/0378-3839(96)00012-9]
9. Zanuttigh, B., Van der Meer, J.W., Lykke Andersen, T., Lara, J.L. and Losada, I.J., (2008), Analysis of wave reflection from structures with berms through an extensive database and 2DV numerical modelling. Coastal Engineering ICCE, Hamburg, Germany.
10. Zanuttigh, B. and Lykke Andersen, T., (2010), Wave reflection in 3D conditions, Coastal Engineering, Vol. 57, p.531-538. [DOI:10.1016/j.coastaleng.2009.12.006]
11. Miche, R., (1951), Le pouvoir réphléchissant des ouvrages maritimes exposés à l'action de la houle. Annales de Ponts et Chaussées, 121è Année, p.285-319. (In French)
12. Battjes, J. A., (1974), Surf Similarity, 14th International Conference on Coastal Engineering, Copenhagen, Denmark. [DOI:10.9753/icce.v14.26]
13. Losada, M.A. and Gimenez-Curto, L.A., (1979), The joint effect of the wave height and period on the stability of rubble mound breakwaters using Iribarren's number, Coastal Engineering, Vol. 3, p.77-96. [DOI:10.1016/0378-3839(79)90011-5]
14. Seelig, W.N. and Ahrens, J.P., (1981), Estimation of wave reflection and energy dissipation coefficients for beaches, revetments and breakwaters, Coastal Engineering Research Center Fort Belvoir VA, (No. CERC-TP-81-1). [DOI:10.5962/bhl.title.47482]
15. Postma, G.M., (1989), Wave reflection from rock slopes under random wave attacks, Master Thesis. Delft University of Technology.
16. Hughes, S.A. and Fowler, J.E., (1995), Estimating wave-induced kinematics at sloping structures, Journal of waterway, port, coastal, and ocean engineering, Vol.121(4), p.209-215. [DOI:10.1061/(ASCE)0733-950X(1995)121:4(209)]
17. Chegini, V., Aghtouman, P. and Saghri, N., (2000), Wave Reflection from Rubble-Mound Breakwaters. 4th International conference on coasts, ports and marine structures, Tehran.
18. Muttray, M., Oumeraci, H. and Ten Oever, E., (2006), Wave reflection and wave run-up at rubble mound breakwaters, Coastal Engineering, ICCE, San Diego, California.
19. Zanuttigh, B. and Van der Meer, J.W., (2006), Wave reflection from coastal structures, Coastal Engineering ICCE, San Diego.
20. Zanuttigh, B. and Van der Meer, J.W., (2008), Wave reflection from coastal structures in design conditions, Coastal Engineering, Vol.55, p.771-779. [DOI:10.1016/j.coastaleng.2008.02.009]
21. Calabrese, M., Di Pace, P. and Buccino, M., (2008), Wave Reflection at Low Crested Breakwaters Ranging from Submerged to Exposed, 31th International Conference on Coastal Engineering, Hamburg, Germany.
22. Park, O.Y., Dodaran, A.A., Bagheri, P., Kang, K.U. and Park, S.K., (2013), Reflection and Transmission Coefficients for Rubble Mound Breakwaters in Busan Yacht Harbor. Journal of Ocean Engineering and Technology, Vol. 27(6), p.90-94. [DOI:10.5574/KSOE.2013.27.6.090]
23. Van der Meer, J.W. and Sigurdarson, S., (2016), Design and Construction of Berm Breakwaters, World Scientific Publishing Co. Pte. Ltd. [DOI:10.1142/9936]
24. Mahmoudi, A., Hakimzadeh, H., Ketabdari, M.J., Cartwright, N. and Vaghefi, M., (2017), Experimental Study on Wave Transmission and Reflection at Impermeable Submerged Breakwaters. International Journal of Coastal and Offshore Engineering, Vol. 1(3), p.19-27.
25. Buccino, M., D'Anna, M. and Calabrese, M., (2018), A study of wave reflection based on the maximum wave momentum flux approach, Coastal Engineering Journal, Vol. 60, p.1-21. [DOI:10.1080/05785634.2017.1418796]
26. Van der Meer, J.W., (1988), Rock slopes and gravel beaches under wave attack, PhD Thesis. Delft University of Technology.
27. Melby, J.A. and Hughes, S.A., (2003), Armor stability based on wave momentum flux, Coastal Structures Conference, ASCE, New York.
28. Goda, Y. and Yasumasa, S., (1976). Estimation of Incident and Reflected Waves in Random Wave Experiments, 15th Coastal Engineering Conference, Honolulu, Hawaii. [DOI:10.9753/icce.v15.47]
29. Mansard, E.P.D. and Funke, E.R., (1980), The measurement of incident and reflected spectra using a least squares method, 17th Coastal Engineering Conference, Sydney, Australia. [DOI:10.9753/icce.v17.8]
30. Dai, Y.B. and Kamel, A.M., (1969), Scale Effect Tests for Rubble Mound Breakwaters, U. S. Army Engineer Waterway Experiment Station, Corps of Engineers, Vicksburg, Mississippi, Research Report H-69-2.
31. Thomsen, A.L., Wohlt, P.E. and Harrison, A.S., (1972), Riprap Stability on Earth Embankments Tested in Large-and Small-Scale Wave Tanks, CERC Technical Memorandum No. 37, U.S. Army Corps of Engineers.
32. Broderick, L.L. and Ahrens, J.P., (1982), Riprap Stability Scale Effects, CERC Technical Paper 82-3, U.S. Army Corps of Engineers.
33. Jensen, O.J. and Klinting, P., (1983), Evaluation of scale effects in hydraulic models by analysis of laminar and turbulent flow, Coastal Engineering, Vol.7, p.319-329. [DOI:10.1016/0378-3839(83)90002-9]
34. Burcharth, H.F. and Frigaard, P., (1987), On the Stability of Berm Breakwater Roundheads and Trunk Erosion in Oblique Waves, In Berm Breakwaters, workshop at NRC, Canada, Ottawa, ASCE.
35. Wolters, G., van Gent, M., Allsop, W., Hamm, L. and Muhlestein, D., (2010), HYDRALAB III: Guidelines for physical, model testing of rubble mound breakwaters, 9th international conference organized by the Institution of Civil Engineers and held in Edinburgh. [DOI:10.1680/cmsb.41318.0062]
36. Scheffer, H.J. and Kohlhase, S., (1986), Reflection of irregular waves at partially reflective structures including oblique wave approach, 20th Conference on Coastal Engineering, Taipei, Taiwan. [DOI:10.9753/icce.v20.162]
37. Ehsani, M., Moghim, M.N., and Shafieefar, M., (2019), The effect of stone class I characteristics on hydraulic stability of multilayer berm breakwaters, Journal of Marine Engineering, Vol. 15(30), p.53-67. [DOI:10.29252/marineeng.15.30.53]
38. Ehsani, M., Moghim, M.N., and Shafieefar, M., (2020), An experimental study on the hydraulic stability of Icelandic-type berm breakwaters, Coastal Engineering, Vol.156, 103599. [DOI:10.1016/j.coastaleng.2019.103599]
39. Sveinbjörnsson, P.I., (2008), Stability of Icelandic type berm breakwaters, Master Thesis. Delft University of Technology.
Send email to the article author

Add your comments about this article
Your username or Email:

CAPTCHA


XML     Print



Back to the articles list Back to browse issues page
International Journal of Coastal and Offshore Engineering International Journal of Coastal and Offshore Engineering
Persian site map - English site map - Created in 0.05 seconds with 31 queries by YEKTAWEB 4241